|
- Carlor's heating is an electric preheating system designed for heat engines with water cooling. It is a universal, reliable, easy-to-install system that does not require any maintenance. Topstart is for the heating of cooling fluid and of windscreen wiper fluid. The advantages on offer are many:
- Fuel economy
- Pollution control
- Reduction in engine wear
- Prevention of ignition problems in cold weather
- Driver's compartment of vehicle is heated directly
|
|
- Heating assembly - Base - Hoods
All-aluminium construction for many years of service.
Shock- and corrosion-resistant.
Perfect enclosure of heating assembly.
Admitted diameter: 1/2".
- Regulation thermostat for water temp.
Adjustable range from 0 to 80°C.
Interrupting capacity: 16 A.
- Cut-out thermostat
Protection in the event of overheating.
Manual reset.
Temperature measured at the level of the heating element for immediate reaction.
Interrupting capacity: 25 A.
Temperature setting: 110 °C.
- Electric immersion heating
Dust-protected Incoloy 800 ® stainless steel
Power: 1,000 to 2,500 Watts 1~230 volts
Specific maximum charge of 7.5 W/cm²
Highly compact element thanks to spiral structure.
Total length of element, spiral uncoiled:
1000 w: 0,6 m
1500 w: 0,9 m
2000 w: 1,2 m
2500 w: 1,6 m
- Circulation pump for water circuit
Allows rapid and homogeneous heating of all engine parts. Considerably increases the useful life of the heating assembly.
Enclosure rating IP68.
Unblockable motor. Wet pit pump.
Absorbed electrical power P1 of 28 Watts.
Maximum absorbed current at full Imax charge of 0.34 A.
Nominal tension for single-phase 230-Volt supply: Approx. 10% in accordance with European standard IEC 38.
Nominal Frequency: 50 Hertz
Average output: 600 litres/hour
Maximum manometric height: 1.27 mce
Maximum fluid temperature admissible: 65°C in open circuit (hard water) and 110°C in closed circuit (demineralised water)
Water/glycol mixture: Maximum ratio 1:1.
Wheel: Fibre glass-reinforced polypropylene.
Bearings: Graphite.
Shaft: Stainless steel type X 35 CrMo17 ( 0.35% C, 17% Cr, 1% Mo).
|
